TX1_0=LEVEL_AT_THE_TD_PIN_, SILENT=NORMAL_OPERATION_, BASIC=BASIC_MODE_DISABLED_, RX=THE_CAN_BUS_IS_DOMIN, LBACK=DISABLED
Test register
| RESERVED | tbd. |
| BASIC | Basic mode 0 (BASIC_MODE_DISABLED_): Basic mode disabled. 1 (IF1_TX_if2_rx): IF1 registers used as TX buffer, IF2 registers used as RX buffer. |
| SILENT | Silent mode 0 (NORMAL_OPERATION_): Normal operation. 1 (SILENT): The module is in silent mode. |
| LBACK | Loop back mode 0 (DISABLED): Loop back mode is disabled. 1 (ENABLED): Loop back mode is enabled. |
| TX1_0 | Control of TD pins 0 (LEVEL_AT_THE_TD_PIN_): Level at the TD pin is controlled by the CAN controller. This is the value at reset. 1 (THE_SAMPLE_POINT_CAN): The sample point can be monitored at the TD pin. 2 (TD_PIN_IS_DRIVEN_LOW): TD pin is driven LOW/dominant. 3 (TD_PIN_IS_DRIVEN_HIG): TD pin is driven HIGH/recessive. |
| RX | Monitors the actual value of the RD Pin 0 (THE_CAN_BUS_IS_DOMIN): The CAN bus is dominant (RD = 0). 1 (THE_CAN_BUS_IS_RECES): The CAN bus is recessive (RD = 1). |
| RESERVED | Reserved |